Six lines of work, all fabricated and installed by the same team. Mix them on one job — most of ours are a fence run with at least one gate in it.
Full boundary runs, shared dividing fences, side returns and infill panels in Colorbond steel, with matching capping and pedestrian gates.
Standard and extended heights, with lattice or slat tops where you want extra privacy without rebuilding the whole run.
Steel sheet · powder-coated · colour matched
Driveway gates supplied, hung and automated: motor, track or ram, remotes, keypad or intercom provision, and safety beams across the opening.
We align and test the gate manually before the motor goes on, because automation magnifies every fault it inherits.
Sliding · swing · cantilever
Flat-top and loop-top aluminium barriers with self-closing, self-latching gates, set out for the barrier heights, gap limits and non-climbable zone that apply to pool areas.
Also used for front fencing, garden divisions and courtyard screens where you want a see-through line.
Aluminium tube · self-closing hardware
One-off fabrication for openings that no stock panel fits: wide driveway leaves, curved-top frames, slatted privacy screens and steel balustrade.
Frames are welded and finished in the workshop, then hung and adjusted on site.
Welded frames · made to measure
Fencing over falls, on top of retaining walls and across driveway crossovers, raked so the rails follow the ground instead of stepping away from it.
Post depths and footings are sized to the finished height and the ground you are actually building in.
Raked runs · retaining-top fixings
Replacement panels and posts after wind or impact damage, re-hanging dropped gates, and re-aligning hinges, latches and drop bolts.
Gate automation servicing too: motor adjustment, limit and force resetting, remote pairing and safety beam checks.
Panel swaps · gate & motor servicing
A fencing quote that says nothing but a total is impossible to judge. Ours sets out what is being built and what it is being built from, so a like-for-like comparison is actually possible.
The same fabrication and set-out process runs across all three — only the scale and the scheduling change.
Replacement boundary fences, pool barriers before an inspection, and a driveway gate that finally makes the front of the property secure.
Fencing on new-build lots and subdivisions, quoted off the plan and set out on site once levels and crossovers are final.
Yard and car park fencing, strata driveway gates, and servicing on automation that a body corporate needs kept working.
Describe the job in a sentence or two and send it through. If it is not something we do, we will say so rather than quote it.