Fencing & automated gates · Perth, Western Australia

Colorbond fencing and automated gates, measured and installed across Perth.

Bc Fencing & Gates fabricates and installs boundary fencing, pool barriers and motorised gates for homes, builders and commercial sites throughout Western Australia.

Request a quote See what we build

Australian-registered · ABN 93 699 851 637 · Based in WA 6111

Line drawing of a slat fence and automated sliding gate raked to a sloping block A horizontal slat fence panel on the left, a motor housing at the gate post, and a raked sliding gate whose top and bottom rails follow the fall of the ground.
How we work

Fences fail at the ground line. That is where we start.

Perth blocks slope, sand moves and driveways cross boundaries at awkward angles. Every job is set out on site before a single panel is cut.

Set out on the ground

We walk the boundary and record the falls, retaining heights, service runs and the clearance a gate needs before it fouls a driveway or a verge.

Cut to the measured run

Panels, frames and gate leaves are made to the lengths taken on site, so rails rake with the slope instead of leaving wedge-shaped gaps underneath.

Built to be serviced

Motors, receivers and safety beams go in with accessible cabling and a documented setup, so a future fault is a service call rather than a rebuild.

What we build

Boundaries, barriers and gates

Residential, builder and light-commercial work in steel and aluminium, fabricated and installed by the same team.

Colorbond & boundary fencing

Full boundary runs, side returns and infill between neighbours, in standard and extended heights with matching gates and capping.

Steel · powder-coated finish

Automated sliding & swing gates

Driveway gates with motors, remotes, keypads and safety beams, wired so the hardware can be adjusted and serviced later.

Sliding · swing · cantilever

Pool barrier & tubular fencing

Flat-top and loop-top aluminium barriers with self-closing gates, set out with the gaps, heights and non-climbable zone the barrier rules require.

Aluminium · self-closing hardware

See all six services and the materials we work in

About the company

Fabricated in the workshop, finished on your boundary

Bc Fencing & Gates Pty Ltd is a Western Australian fencing and gate company working out of WA 6111 and across the Perth metropolitan area. We cut, weld and assemble frames in the workshop, then hang and align them on site.

That split matters. Workshop fabrication keeps the welds square and the finish consistent; site work is where a gate is packed level, a post is set to the right depth in sand, and a rail is raked so the fence follows the fall instead of fighting it.

  • Residential boundaries, side returns and pool barriers
  • Builder and developer runs on new-build lots
  • Light-commercial yards, car parks and strata driveways
More about how we work
Elevation drawings of three fence types: a Colorbond slat panel, a tubular pool barrier and a custom braced gate Colorbond Tubular barrier Custom gate
Company details

Registered, on the record

The details below are the company's registered particulars. We publish them so you can check who you are contracting with before you accept a quote.

ABN 93 699 851 637
ACN 699 851 637
Registered WA 6111
Entity Bc Fencing & Gates Pty Ltd, an Australian proprietary company

Get a price on the run

Send the approximate boundary length, the fence or gate type you want and a photo of the site. We will come back with a written quote.

Request a quote Email us directly